All models
An open library of tested models: mechanics, household parts, enclosures and decor. Every model ships as STL and OBJ, with the print settings it was actually made on.
Fluted vase planter
Ø129 × 183 mm, 3 mm wall, ring-shaped drain slot and a raised floor.
Saucer for the vase planter
Ø113 × 30 mm, a 25 mm deep dish made for the vase-planter pot.
Worm drive 30:1, module 2
Single-start worm and a 30-tooth wheel. Self-locking, 6 mm shaft.
Vented lid for Raspberry Pi 4
Nine slots, locating rim, M2.5 standoff holes.
Corner bracket 60x60 with gusset
Four M4 holes and a gusset. The most downloaded part in the section.
Spur gear, module 2, 24 teeth
20 degree involute, hub with a keyway for an 8 mm shaft.
Laptop riser leg (print two)
92 mm lift, front lip, set them to any laptop width.
Cable clips 4/6/8 mm, set
Three sizes on one plate, screw down with a self-tapper or M3.
Spiral vase, 140 mm
Seven lobes, a 150 degree twist, single wall in vase mode.
Fluted lamp shade 200 mm, E27
1.8 mm wall, 36 flutes, E27 collar moulded in.
Honeycomb shelf, 180 mm
Hex cell with a back panel; tiles into a wall of any size.
Trefoil knot, 90 mm
A (3,2) knot, 13 mm section, from the actual parametric curve.
Spool holder on 608 bearings
Two side frames with a cradle, roller takes two 608 bearings.
D20 blank for engraving
True icosahedron, 22 mm across flats, no numerals.
Planetary gearset 4:1, module 1.5
Sun z18, three planets z18, ring z54 — one file, laid out as it assembles.
Planter 90 mm, drained, with saucer
Seven drain holes, saucer included, fluted wall.
Phone stand, 12 degree lean
One part, no supports, cable channel, works with a case on.
Hex key holder, 7 sockets
Sockets 1.5 to 6 mm in order; one-handed pick-up.
Knurled knob M8 with nut trap
34 mm across, 24 knurls, hex trap for an M8 nut.
Over-door hook, 18 mm leaf
No drilling, holds about 4 kg, will not mark the door.