An open library of tested models: mechanics, household parts, enclosures and decor. Every model ships as STL and OBJ, with the print settings it was actually made on.
20 degree involute, hub with a keyway for an 8 mm shaft.
Seven lobes, a 150 degree twist, single wall in vase mode.
Sun z18, three planets z18, ring z54 — one file, laid out as it assembles.
Hex cell with a back panel; tiles into a wall of any size.
Gears, shafts, anything that turns or carries torque.
Brackets, clips and stands: the parts that hold everything else.
Vases, planters, hooks and shelves. An evening on the printer.
Lids, enclosures and venting for boards and modules.
Organisers, jigs and bench tooling.
Shape for its own sake: prints you make just to look at.
Ø129 × 183 mm, 3 mm wall, ring-shaped drain slot and a raised floor.
Ø113 × 30 mm, a 25 mm deep dish made for the vase-planter pot.
Single-start worm and a 30-tooth wheel. Self-locking, 6 mm shaft.
Nine slots, locating rim, M2.5 standoff holes.
Four M4 holes and a gusset. The most downloaded part in the section.
20 degree involute, hub with a keyway for an 8 mm shaft.
92 mm lift, front lip, set them to any laptop width.
Three sizes on one plate, screw down with a self-tapper or M3.