Laptop riser leg (print two)
92 mm lift, front lip, set them to any laptop width.
Drag to rotateDescription
The file holds one leg: print two and space them to your laptop. That way it fits a 13 inch and a 16 inch alike, and you are not printing a monolith that eats half the bed.
A 92 mm rear lift over 130 mm of depth works out at about 30 degrees. The 24 mm front lip matters: without it the laptop creeps forward, especially on a desk that is not perfectly level.
The two lightening holes take out roughly 40% of the mass and let air under the machine. Print flat, no overhangs. Do stick felt or silicone underneath - PETG slides on a varnished desk.
Comments (2)
Две ножки, PETG, 25% — держат 16" MacBook без прогиба.
Поднял бортик с 18 до 24 мм по просьбам.