Cable clips 4/6/8 mm, set
Three sizes on one plate, screw down with a self-tapper or M3.
Drag to rotateDescription
Three clips for 4, 6 and 8 mm cable. The arch is a true half round with +0.3 mm clearance: the cable snaps in and stays without being squeezed.
The flange takes two 3.4 mm screws, either a 3x16 self-tapper into a wall or an M3 into extrusion. Two holes rather than one because on a single screw the clip rotates, which you discover the moment you pull the cable.
Print flat as laid out. No supports: the arch is a half round and the top bridges less than a nozzle width. A plate of six in each size takes about 40 minutes.
Comments (3)
Сорок штук по гаражу. Ничего лучше пока не нашёл.
Добавьте, пожалуйста, вариант под 10 мм гофру.
Добавил 8 мм в набор и увеличил фланец, теперь не крутится.