Planter 90 mm, drained, with saucer
Seven drain holes, saucer included, fluted wall.
Drag to rotateDescription
Sized for a 90 mm nursery pot. The floor is properly perforated: a 6 mm hole in the centre and six 5.2 mm holes around it. Most printed planters skip this and the roots sit in water.
The saucer is in the same file and prints in the same run; it catches about 60 ml. The fluting is not only cosmetic - the wave hides the seam and stiffens a thin wall.
PETG rather than PLA: the soil is always damp, and PLA does not enjoy constant damp and a warm windowsill. No infill needed; three perimeters give a solid 1.2 mm wall.
Comments (1)
Печатали серию из шести штук на подарки, PETG прозрачный — очень хорошо.