Phone stand, 12 degree lean

Description

The profile is set so a phone in a case does not tip forward and the screen faces you instead of the ceiling. The back rest leans 12 degrees off vertical, which is about eye level at a 75 cm desk.

The trough is 9 mm wide: a cased phone fits without rattling. There is a 9 mm lip at the front and the rest behind. The cable comes up through the channel so the plug clears.

Print it on its side. No overhangs, no supports. 15% infill is plenty; if you want it heavier print at 40% or fill the lower cavity.