Corner bracket 60x60 with gusset
Four M4 holes and a gusset. The most downloaded part in the section.
Drag to rotateDescription
A plain 60x60x40 corner with a gusset. The gusset is not decoration: without it a printed bracket almost always snaps along the fold, because the load runs across the layers.
Holes are 4.4 mm for M4 with clearance. For M5 scale XY to 112%; do not push it to M6, the wall around the hole drops below 2 mm.
Print it in the orientation it opens in: one leg on the bed, the other up. No supports needed, the overhang under the gusset is 45 degrees. Five perimeters matter more than infill here.
Comments (3)
Держит полку с инструментом, четыре штуки на стену. PETG, полёт нормальный.
Масштабировала до 80%, вышли отличные уголки для ящика.
Добавил фаску по низу — раньше первый слой задирало на краю.